Safe to have a 48TB Windows volume?
-
@Pete-S said in Safe to have a 48TB Windows volume?:
@scottalanmiller said in Safe to have a 48TB Windows volume?:
@Pete-S said in Safe to have a 48TB Windows volume?:
I'm not convinced about the "stress" for a rebuild.
It's easy to say. But decades of industry knowledge have accepted it as a known stress. I would not go against that without solid reasoning for it.
Parity rebuilds quite obviously do a lot more work than mirrored copies, over a longer period of time. So that there is additional stress both per drive and across the array is just common sense. That the evidence of this was so strong that it is common knowledge is just expected given the obvious additional wear and tear that hits it all at once.
Yes, it more drives involved as well which increases the risk but is the second failure really more statistically prone to happen during the rebuild process than if you would read the same amount of data from the same number of drives?
I'm not the one that has done the study on this. But it is accepted as commonly known to be statistically significant. So yes, absolutely, 100%... the industry believes that you get a much higher failure rate during that time.
-
@Pete-S said in Safe to have a 48TB Windows volume?:
Have there been so many double failures during rebuild that there is actual data on this? The only thing I've seen has been calculations involving just the number of bits and the likely hood of URE.
It's high enough that it is considered to be true industry wide. It cannot be calculated, because it's not a simply equation like a URE. There are many factors and mechanical stress is a far more subtle type thing. UREs are a nearly stable rate (but not actually) and we use a common number to know the failure rate under ideal conditions.
Mechanical wear increase rates are insanely hard to get math on. The same goes for the URE increase under the same stress. The problem is, both increase enough to be a real problem.
-
@scottalanmiller said in Safe to have a 48TB Windows volume?:
@Pete-S said in Safe to have a 48TB Windows volume?:
@Obsolesce said in Safe to have a 48TB Windows volume?:
@Pete-S said in Safe to have a 48TB Windows volume?:
Just a side note but if you get a double failure on an array all is not lost.
Thing is that most drives are not dead, they have some bad blocks and they get kicked out of the array and when you don't have enough redundancy the array is shut down.
So you remove the bad drive and clone it to a new drive on another machine. For instance using
dd conv=sync,noerrorwhich means that the drive will cloned as good as it can be and any bad blocks are overwritten with zeroes. Now you can put the new drive back in the array and rebuild the array.It will rebuild fine but the file or files that had bad blocks in them will be corrupted and will have to be restored from backup. However the vast majority of the files will be fine.
In theory you could clone both failed drives. And it's unlikely that both drives have bad blocks in the same location. So theoretically speaking it is very likely that all your data is intact. You would need to use the data from the cloning process to know what blocks where bad on each drive and then the rebuild process would have to take that information into into consideration when rebuilding. Or come to think of it, if you could tell the array that all drives are fine and then do a data scrub and the array would be repaired correctly.
If it's a parity RAID, you don't have files on the drive. It's all parity. You get a URE and it's over. If any of that parity data is gone, you can't restore some random parity bit from backup.
If you mean recovering as good as possible from a double failure I wasn't talking about copying files. I was talking about cloning drives - bit by bit.
That can work. But often fails. How often have you seen a parity array recover from that?
And when you do see it happen, how long does that typically take? Time to recover is a factor that is often overlooked in reliability equations. But in the real world, especially with parity, we often have to discuss with customers "given how long this is expected to take to recover, would it not be better to have just lost the data and started over?"
When downtime is days, or weeks, or even months to "protect against data loss", often you just have to give up because it took too long.
I've only had to do it once myself. RAID5 with six drives I think. I think it was 4 TB drives so I guess a 20TB array. The second drive failed during rebuild. Cloned the second failed drive and rebuilt again. There was a problem with the backup so it was more a question of getting as much as possible up again and then figure things out.
But speed is interesting and that should be one of the primary factors when coming up with a strategy on how to backup and restore.
-
@scottalanmiller said in Safe to have a 48TB Windows volume?:
@Pete-S said in Safe to have a 48TB Windows volume?:
The drive doesn't mechanically fail because it's build to work under high load. It can't be thermal because drives would slow down if they get too hot. It's not electrical because the drive doesn't die. So what is it then?
This statement makes no sense. The theory here is that drives don't experience stress, because they are "designed to work under high load." This is simply untrue. Are they "designed to work under high load", sure, whatever that means. But that doesn't change the fact that higher loads create higher stress.
My car's engine is "designed to work up to the red line". Whatever that means. But running the car near red line creates a lot more stress than running it at slower speeds. So engines running near red line regularly die much earlier than ones that do not. And they are mostly likely to die when at their highest RPMs.
Basically you are missing two key facts. The first that designed to work under high load is a meaningless phrase, it tells us nothing other than that some stressful situation is planned for, but failures are planned for, too. So that is not useful in determining anything else. And the second is that higher stress is higher stress regardless of what the drive is intended to handle.
Otherwise, drive failures would be impossible, since no drive is "designed to fail." Since drives do fail, we know that your statement doesn't indicated what you were saying.
If we look at the mechanical stress a rebuild is not so bad because it's sequential reading and writing. The disks are spinning regardless if you are reading or writing or doing nothing so that makes no difference. And the arms don't have move all over the place when you're doing sequential block operations.
But what I was implying is that the second drive doesn't fail for a mechanical reason because that would be the end of the drive. Isn't that your experience as well, that you end up with bad blocks but not dead drives?
-
@PhlipElder said in Safe to have a 48TB Windows volume?:
@FATeknollogee said in Safe to have a 48TB Windows volume?:
@PhlipElder said in Safe to have a 48TB Windows volume?:
(BUE failed us so we moved to Storagecraft ShadowProtect which has been flawless to date).
What is BUE?
Sorry, I should have broken the acronym out. It's Backup Exec at one time by Colorado when it was an awesome product then Symantec when things went downhill from there.
Now they are Veritas just in case you wonder.
-
@dbeato said in Safe to have a 48TB Windows volume?:
@PhlipElder said in Safe to have a 48TB Windows volume?:
@FATeknollogee said in Safe to have a 48TB Windows volume?:
@PhlipElder said in Safe to have a 48TB Windows volume?:
(BUE failed us so we moved to Storagecraft ShadowProtect which has been flawless to date).
What is BUE?
Sorry, I should have broken the acronym out. It's Backup Exec at one time by Colorado when it was an awesome product then Symantec when things went downhill from there.
Now they are Veritas just in case you wonder.
No actually. It has been Veritas since 1999.
Had to google it to get the year, I didn't recall that.
https://en.wikipedia.org/wiki/Backup_Exec#History -
@JaredBusch said in Safe to have a 48TB Windows volume?:
@dbeato said in Safe to have a 48TB Windows volume?:
@PhlipElder said in Safe to have a 48TB Windows volume?:
@FATeknollogee said in Safe to have a 48TB Windows volume?:
@PhlipElder said in Safe to have a 48TB Windows volume?:
(BUE failed us so we moved to Storagecraft ShadowProtect which has been flawless to date).
What is BUE?
Sorry, I should have broken the acronym out. It's Backup Exec at one time by Colorado when it was an awesome product then Symantec when things went downhill from there.
Now they are Veritas just in case you wonder.
No actually. It has been Veritas since 1999.
Had to google it to get the year, I didn't recall that.
https://en.wikipedia.org/wiki/Backup_Exec#HistoryNo, they were bought up by Symantec between 2005 and 2015
-
@dbeato Even when Symantec bought them the product was still called Veritas for a while until they got around to rebranding. and the older, supported versions were never rebranded.
It was Veritas since 99. and Backup Exec since 93
-
I worked at Veritas in 2004-2005 and was there when the buyout happened. It was in 2004 that they bought it, 2005 that they rebranded.
-
Fight - fight - fight...
