Issue with XenServer Node
-
There is no ARP table entry for it.
-
@scottalanmiller They worked fine, then @art_of_shred played with he network a bunch. No idea what happened. And no, there was no VLAN tampering.
-
Okay, well the current status is that that node is not on the network. Have you looked at the cables to see if they are correct?
-
@scottalanmiller Of course
It's on, and plugged in. -
Can that node ping anything else, like the gateway?
-
@Mike-Ralston said:
@scottalanmiller Are you crazy? It's Saturday.
Worked til 4am last night, been at it since 10 am this morning.......i feel ya scott
-
@scottalanmiller How do I ping something from it? It's not a command prompt.
-
@Mike-Ralston said:
@scottalanmiller How do I ping something from it? It's not a command prompt.
Should be a way, you are looking at Linux attached to the console.
Have you tried basic things like switching the cable to a different port on the switch?
-
Did you try rebooting? You needed to reboot while working on the BIOS update to enable virtualization anyway.
-
@scottalanmiller I'll reboot it again: I did try that.
-
Didn't work.
What all have you tested thus far? What lights are on on the switch, has the port been switched? Have you switched the port on the server itself? It's very hard to assist when I only get partial information. -
The server has been rebooted twice. The cable was switched from eth port 1 to 2, and the other end at the switch was removed and reseated. Still not reachable by ping from my computer on the network. I'll try another switch port, but I don't think that's it.
-
Different port on the switch, still no reply.
-
It's back on the network. It always was. Even though the IP was not changed in the management console, and it even showed correctly, when it booted up it somehow assigned itself to .26. No clue why, but refreshing the management settings put it right and I added it as a server to Xen Center again and it's connected and pingable on the network and all that good stuff.
-
@art_of_shred said:
It's back on the network. It always was. Even though the IP was not changed in the management console, and it even showed correctly, when it booted up it somehow assigned itself to .26. No clue why, but refreshing the management settings put it right and I added it as a server to Xen Center again and it's connected and pingable on the network and all that good stuff.
Awesome, thanks.
-
The IP address is pingable now, but it is still showing as disconnected in XenCenter.
-
@Mike-Ralston said:
@scottalanmiller How do I ping something from it? It's not a command prompt.
It should be, you have the other machine at a command prompt...
-
@scottalanmiller that was me when I was checking the connectivity...
-
Found what the issue was with the Red X.... it was crash dump files for the host.
Click on the server with the right mouse button. There you see "Remove crash dump files.
-
Got the SAN issue addressed too. That was actually a setup issue on the Drobo. If you don't select "Cluster" on the Volume tab it will lock out all but the first node to connect to it. Unselect that and then right click on the SAN in the pool and select "Repair" and it will attempt to connect again and ta da. All set.
